Bias Binder 6mm

Machine Compatibility: 1, 2, 3, 4, 5, 6, 7, 8, 9

Not sure which group your machine belongs to? Check out the Machine Compatibility Chart

Binding with this Bias Binder foot is a breeze! You can use pre-packaged bias tape or you can make your own to use.

To bind edges with 1/4" (6 mm) Bias Binding, cut a 1" (24 mm) wide bias strip of lightweight fabric, or use packaged narrow
double fold Bias Binding. Straight stitch, length 2.5, or zigzag or decorative stitch at the desired length.

1. Snap on Bias Binder.
2. Cut the end of the bias tape to a point. Insert the bias tape from the outside of the funnel guide, into the slot and pull it down under the foot.
3. Place the edge to be bound into the groove on the left side of the funnel guide.
4. Adjust needle position as needed or to adjust the position of the binder funnel/guide, loosen the screw on the top of the foot, and position the funnel guide as needed.